• Long-life tungsten contacts
  
• Gray finish
  
• High grade copper coils
  
• Hinged cover
  
• Normally open circuit relay
  
• Two shading coils prevent armature clatter

The Edwards electro-mechanical, pressed steel, telecode relays are designed to activate up to 5 vibrating-type horns, buzzers, and bells. The unit's windings are rated in ohms rather than volts. Wire size and number of turns vary with resistance requirements.

The B-8316 series relay is supplied with a capacitor; the B-8315 series is not. If a capacitor is required, order the Cat. No. B-8325 one microfarad, 400V capacitor with bracket.

Unit mounts to any flat surface using the mounting holes on 3 3/8" (86 mm) centers. 1/2" (13 mm) and 3/4" (19 mm) knockouts are provided for input and output wiring.

Relays operating on AC ringing voltage and used on common battery circuits require capacitors. Relays operating on DC ringing voltages do not require capacitors unless energized by a common battery.

For areas where ambient noise levels are high or where personnel are unable to be near telephones at all times such as factories, loading docks, mines, quarries, lumber yards, gas stations, foundries, etc.

Ordering Information
Specify pull up coil resistance, voltage, and frequency data. For standard phone system ringing circuits, specify same coil resistance as bell ringer coils. For intercommunicating phone ringing circuits, specify relays of same voltage and frequency as ringing circuit.